Description
SPECIFICATIONS
Brand Name: grandnavi
Hign-concerned Chemical: None
Model Name: MS-30RV
Origin: Mainland China
Output Power: 25W
Voltage: 12V
Specifications:
Electrical Specifications
Operating Voltage：12V DC(10V-15.9V allowable)
Standby Current Draw：5mA
Fuse Value：15A
Audio Outputs/Inputs
Output Channels：4 stereo pairs of RCA plugs
Maximum Output Voltage：Absolute:2VRMS
Input Channels：1 stereo pair of RCA plugs
Tuner
FM Tuner：87.5 MHz to 107.9MHz (0.2MHz step)
AM Tuner：530kHz to 1710 kHz (10kHz step)
Bluetooth*
Profle：A2DP
USB 2.0
Maximum Current Output：1A
Supported Audio Formats：MP3,WMA,FLAC,AAC,APE
Dimensions
Unit Dimension：134.6mm(5.3") x 84.5mm(3.33"') x 97mm (3.82")
Mounting Hole Dimension：104mm (4.1")x 54mm (2.13")
Features:
Source Type:FM,AM,Bluetooth Enabled Marine Radio.
Input Types:Bluetooth, USB,AUX.
Outputs:1 pair RCA Pre-Amp Out,One Way Input
*Support RCA subwoofer audio output.
*ID3 Tag Song Readout and Power-off Memory is supported.
Ideal for:Car,motorcycles,yacht,fishing boats, cuddy cabins, ski boats , the unit is also perfect for spa pools, quad bikes, golf carts,UTV,ATV and RV.
Support FM/AM Radio Support EQ
IPX5 waterproof
Our radio power cord and connected interfaces are strictly watorproof, and even RCA interfaces that are not connected will be equipped with waterproof covers.
How to install？
1) Choose a mounting location on the dash board or instrument panel that will allow room behind to run radio cables to thepower source. Consider how you will use the AUX IN, LINEOUT and USB connectors and route the appropriate extension cables to an accessible area.
2) Cut a hole in the dashboar, the hole size is about 136x86mm( 5.35×3.38 inch).
3)Place the source unit into the opening holes remain aligned with the pilot hole .
4)Remove the source unit and drill four (4) pilot holes in the mounting surface at the pilot hole marks.
Do not mount this unit where it can be submerged in water.
5) Connect all wiring and place the source unit into the opening.
6) Secure source unit using the four (4) stainless steel screws.
7) After completing the wiring connections, turn the radio on to confirm operation(vehicle accessory switch must be on). If the radio does not operate, recheck all wiring until the problem is corrected. Once proper operation is achieved, turn the accessory switch off and proceed with final mounting of the radio.
Reviews
There are no reviews yet.